Company Evidence · Exhibition Recap
QintelliM exhibited metal deburring and surface finishing equipment at the 20th Shandong Equipment Expo in Jinan, China, held from February 27 to March 2, 2025. The photographs below document QintelliM's physical exhibition presence, equipment display and on-site exchanges with visitors. They are company-event evidence, not machine-performance test results or customer-purchase records.
Event: 20th Shandong Equipment Expo (第20届山东装备博览会)
Dates: February 27–March 2, 2025
Venue: Shandong International Convention and Exhibition Center, Jinan, China
The booth photograph shows equipment on display, visitors in the exhibition hall and the Chinese company name 山东千牟智能科技有限公司 on the booth signage. QintelliM is the brand of Shandong QintelliM Co., Ltd.
The display provided a setting for equipment introductions and application discussions. QintelliM's work covers metal deburring, edge rounding and surface finishing, with machine configuration reviewed against the requirements of each application. The photographs do not establish a specific machine model, station sequence or measured processing result.
Visitors viewed the equipment and spoke with the QintelliM team at the booth. These photographs record equipment introductions and on-site exchange; they do not establish the visitors' commercial roles or purchasing intentions.
The historical poster below records the event dates and venue. The event name used here is the short name supported by the poster and the original article. This is a first-party exhibition record; it is not an organizer endorsement or an independently verified exhibitor listing.
The photographs alone do not prove orders, contracts, customer acceptance or satisfaction, or official third-party endorsement. They do not prove machine performance, throughput, burr-removal percentage, edge radius, surface roughness (Ra), production capacity, productivity gains or specific processing results. No measured performance claim or customer result is presented in this recap.
For current equipment selection, visit General Machine Selection. Equipment suitability should be reviewed against the material, part geometry, incoming edge condition and required finish. The exhibition photographs are not a substitute for an application review or sample testing.
Share your material, part dimensions, incoming condition and finishing requirements with QintelliM for an application review.
Need a Machine Recommendation?
QintelliM can recommend a suitable deburring, edge rounding, oxide removal, slag removal, brushing, polishing or dust collection configuration based on your parts and production needs.